Ka-RAZY overheating glitch

[NancyRogers]

I soaped a batch yesterday that accelerated slightly, but gelled super fast and then overheated a bit. This morning when I went to cut it, it was a little oily on the outside, but the oil was just a slight film, not zappy at all and tasted like the FO smells. Okay, no problem. On the Tank it went. Well the pressure of the wires squished it a bit before it cut and out came more FO. It's still sweating and when I press down on the bars, they sweat even more FO. :shock: :roll: What the heck?! Anyone else experience this before?

 

[soapbuddy]

Sometimes overheated batches will do that. I would leave it be for now and see if it absorbs back in.

 

[heyjude]

GRRRRR! I've not had that happen with the cutting (so jealous of your Tank!), but did just make a batch a few days ago which needed time for the fo to reabsorb. Thankfully, it did.

Hope it works out!