Howdy! Need suggestion for release oil for MW Molds

[alegreone]

Hi, I love MW molds but I'm going crazy losing a lot of bars because the design often doesn't stay when I pull the soaps out. I lose about 50 percent of the bars--too much. I usually freeze the molds an hour or so to help them pop out. I have tried various kinds of olive oils--from pomace to EV, from brushing them thickly to laying it in thinly. I still only pull a cleanly molded soap about half the time. Wondering if anyone has any suggestion for a better release agent? I've also tried mineral oil, but no luck with that.
Thanks in advance! :-D

 

[Yvonne]

I use petrolium jelly, seems helping me

 

[Hazel]

Several people have mentioned using food grade spray silicone like this one.

http://www.webstaurantstore.com/lubriqu ... IQUIK.html

I haven't used it myself so I can't verify how well it works. I hope this helps.

 

[Hestey]

I don't use anything. Mine pop out no problem after a couple of days. If they stick at all I was told freeze it over night and it will pop right out, then let it defrost before you do any trimming or cutting.

 

[Fragola]

Freezing helps, but you need more of it (either more time, or lower temperatures).

 

[alegreone]

Re Release Problem

Thank you to everyone for your suggestions. I really appreciate it!

 

[IrishLass]

I use a very light coating of mineral oil.

IrishLass