Summer star project

Soapmaking Forum

Help Support Soapmaking Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

copper

Well-Known Member
Joined
Dec 29, 2006
Messages
88
Reaction score
1
Location
Seattle
Stand-Up Stars

The shape of a star always catches the eye. Decorate wooden stars with vintage buttons, torn-fabric bows, and twisted wire.

l_12766837.jpg



What You Need:

Tracing paper
Pencil
1/2- to 1-inch-thick pine
Star pattern(s) in size desired
Scissors
Band saw
Sandpaper
Tack cloth
Newspapers
Acrylic paints in desired colors
Paintbrush
Wood glue
Thick white crafts glue
Buttons
Fabric scraps
Wire and wire cutters
Round pencil, small dowel, or wooden skewer

Instructions:

1. Trace a star pattern onto tracing paper. Cut out shape and transfer the pattern to the wood.

2. Using a band saw, carefully cut on the pattern lines. Sand the edges until they are smooth. Wipe away dust from sanding using a tack cloth.

3. Cover your work area with newspapers. Using a desired color, paint one side and the edges of the star. Let the paint dry. Turn the star over and paint the other side. Let it dry. Apply second coats if needed. Let the paint dry.

4. Sand the edges of the star again to provide a weathered look. Remove any dust from sanding with tack cloth.

5. If desired, layer a small star on top of a larger one. Glue the stars together using wood glue. Let the glue dry.

6. For the button stars, use thick white crafts glue to affix a button to the center of the star. Let the glue dry. You can glue two or three buttons atop each other, or glue several small buttons on the star if desired.

7. For the bow star, tear a narrow strip from fabric, approximately 1 inch x 12 inches. Place the fabric strip diagonally across the back of the star. Tie the fabric strip into a bow on the front side of the star. Glue the bow in place if desired. Trim the ends even.

8. For the wire-wrapped star, wrap a long length of wire around the center of the star as desired. Twist the wire ends together to secure. Trim the ends of the wire, leaving about 3 inches on each end. To make coiled ends, wrap the wire ends around a round pencil, small dowel, or wooden skewer. Remove the pencil or dowel. Shape the wires as desired.
 

Latest posts

Back
Top