allinalather
Well-Known Member
After I have poured into the moulds, I spritz with rubbing alcohol to get rid of air bubbles. The surface, once the soaps are ready to de-mould, still look a little "rustic". I know that I could cut away the rough part, but is there anyway this could be made smooth during the cooling process? The moulds are a little less than 1 inch deep.
I did think about rubbing the bottom of the soap on a baking tray whilst it was on the gas burner of the hob, but I thought I would ask here first.
I did think about rubbing the bottom of the soap on a baking tray whilst it was on the gas burner of the hob, but I thought I would ask here first.