Wow, you all have some very impressive soaps there.
Here is my entry, colored with 2 strengths of alkanet infused oil. If it morphs to purple I will update you.
The bolts on mine are welded on. I will have a go at prising them off. I think I might be better with a block, at least that way they soap can’t move much.
Hi there,
Totally butchered the cut of my bar.
I normally use a multi bar cutter, I bought this as I was not very great with my single wire and had a few uneven bars.
Even the cut into blocks was not possible with my single wire as the bolts are too close to the wire. So I used a knife Resulting...
My first attempt at a Taiwan Swirl today. The batter started to thicken quite quickly and was was plopped in between the dividers. The top looks very lumpy And the sides, where I went round are a bit messy. The colours are white and then 2 shades of alkanet, hopefully one will be darker than the...
Sign Up List:
1. jcandleattic - hopefully will have time to do this one.
2. Misschief - been wanting to do this again for a while
3. KimW - One I've been wanting to try! Yippeeeee
4. GemstonePony - I love this swirl!
5. DKing - I'm looking forward to seeing what I can come up with
6. catscankim...
I cut this soap today. It is made with chocolate and scented with Orange EO.
Quite pleased with the embed, the mica line is too fine. I don’t know what caused the drag line on every bar, I use a multi bar cutter.
Today I tried my first soap with an embed running the length of the loaf. I will not know until tomorrow whether it has been a success or not. Oooo the anticipation!,
Haha, this reminded me of a review I read some years ago. It has only taken me an hour’s browsing to find it. Laughed my socks off when I read this the first time.
This blog was not the original review that I read but here was the first place that I found it...