Help Support Soapmaking Forum:
-
-
Bilemiyorum Altan replied to the thread Whitening problem after unmolding..OMG :( :( That means I was changing wrong number about water amount for the lye... :( Thank you... yes I should use Lye Concentration... -
Bilemiyorum Altan reacted to AliOop's post in the thread Whitening problem after unmolding. with
Like.
Water as percent of oils is a different measurement than the others are using. It can be very inconsistent between batches. Try using... -
Bilemiyorum Altan replied to the thread Whitening problem after unmolding..I never went down less then water as % of oils :30 It scares me. And I could not decide for a few days what kind of recipe I should try...
-
Bilemiyorum Altan reacted to dmcgee5034's post in the thread Whitening problem after unmolding. with Like.
…and learning along the way, @Bilemiyorum Altan 😊
-
Bilemiyorum Altan reacted to KimR's post in the thread Another failure ! Moldy kashar cheese with Like.
I think they look pretty! May not have been the plan but clean off the soda ash and proceed.
-
Bilemiyorum Altan replied to the thread Whitening problem after unmolding..I should have mixed longer. I should have waited longer to unmold them. I am making same mistakes over and over :(
-
Bilemiyorum Altan reacted to dmcgee5034's post in the thread Whitening problem after unmolding. with Like.
Also, try covering with plastic wrap for a few days after unmolding. Between the isopropyl alcohol spritz and the plastic wrap, I’ve...
-
Bilemiyorum Altan reacted to KiwiMoose's post in the thread Whitening problem after unmolding. with Like.
The alcohol won't be much use on the cavity molds - because it's after they're turned out that the ash grows. Some people suggest...
-
Bilemiyorum Altan reacted to Ford's post in the thread Whitening problem after unmolding. with Like.
Hello, like the others. Spritz, wrap after pouring. I also cover curing bars. Sitting on the shelf. With a thin piece. Of regular...
-
Bilemiyorum Altan reacted to ScentimentallyYours's post in the thread Whitening problem after unmolding. with Like.
The ash is appearing because the soap didn’t fully saponify before it was turned out of the mold. If your cavity molds are silicone...
-
Bilemiyorum Altan reacted to Zing's post in the thread Whitening problem after unmolding. with Like.
GREAT looking soap there! Congrats! Ditto to all the above. I've learned when using single cavity molds to leave 'em be for a week...
-
Bilemiyorum Altan reacted to TheGecko's post in the thread Making soap became an addiction . with Like.
You should try knitting...it's even worse because you're always finding more yarn than you can possibly have time to knit up.
-
Bilemiyorum Altan reacted to KiwiMoose's post in the thread Making soap became an addiction . with Like.
We've all been there - it's completely normal 🤪 You'll have to start showering 5 times a day!
-
Bilemiyorum Altan reacted to 2lilboots's post in the thread Making soap became an addiction . with Like.
Take up sewing you will have fabric stashed in every closet and end up with over 7 sewing machines.
-
Bilemiyorum Altan reacted to Relle's post in the thread Making soap became an addiction . with Like.
You can never have enough yarn. Lot's of fabric here, only 2 sewing machines, one hubby bought for me one christmas many moons ago and...
-
-
Loading…
-
Loading…